Okay, we’ve got all our parts for the $450 system I’ve been discussing lately (Part1, Part 2, Part 3), and now it’s time to put it all together. It’s not all that difficult to do. I was hesitant the first time, all those years ago, but there’ s no fear anymore. Just be mindful of static electricity.
Note: When assembling the system parts, make sure you’re not in a place that will create static electricity, like on a carpet. The static charge could potential damage the sensitive electronic parts. I have a work desk on a wooden floor. Anything but carpet.
- Install the motherboard into the case with the screws provided. Follow the instructional manual.
- Connect the power supply lines for the CPU, motherboard, and any other locations as per the mainboard’s instruction manual.
- Connect case wires to the motherboard. Again, consult the mainboard’s manual. Typical connections are:
- the power switch and reset switch which typically are on the same wire.
- any front or side panel USB connections
- any front panel audio connectors for headphone or microphones.
- any cooling fans attached to the inside of the case
- Mount the processor and its cooling fan on the motherboard as shown in the motherboard’s manual and the processors manual. Connect the fan line to the motherboard, too.
- Install the RAM (memory) on the motherboard. Real easy. Snap! Snap!
- Install the DVD and hard drive.
- Attach a power supply cable to each.
- Connect each drive’s SATA cable to the motherboard.
- You might consider closing the case after you’ve installed your operating system. Just in case have to check your connections from the previous steps. If you have any pets who might find the insides curious, I’d seal it now.
- Connect your old keyboard, mouse, and monitor. If you need a new mouse and keyboard, you can get them for less than $20 each at many computer and office supply stores.
- Plug in the power cables for the monitor and case to a wall outlet or power strip.
- If you have high speed Internet service such as cable or DSL, you connect it to the back of the case.
- Power on the monitor and the CPU case.
- Check the motherboard’s manual about the BIOS settings that will pop up the first time you start the computer. Usually the “default” settings will be fine. (Don’t be alarmed here. It’s not big deal.)
- Insert the Windows 7 DVD into the DVD burner drawer. Restart the computer if necessary. Windows 7 will now install.
Windows 7 will take about a half hour to install. Give it time. Just follow the steps onscreen and you’ll have no problem at all. I’ve installed many versions of Windows, and I have found Windows 7 to be the easiest one ever.
After Windows is installed you can install any other software you might have.
Got an old PC you want to move files from? Just use the Windows Easy Transfer tool under Accessories and System Tools on the Programs menu. (I’ll discuss this one another time. Promise.) It’s easiest if you have a router and can wire your PCs to the router.
I’ll suggest some other software you can find online tomorrow. Stay tuned!